Digital Projection Ltd. E-Vision Laser 13000 WU Series
3D connections
3D connections
1
2
5
WIRED
REMOTE
HDBaseT/LAN
HDMI 1
DISPLAYPORT
DVI-D
IN
OUT
HDMI II
IN
TRIGGER
I
II
RS-232
V
H
B/Pb
G/Y
R/Pr
VGA
OUT
MONITOR OUT
SDI
3D SYNC
3
6
4
1.
HDBaseT
Receives 3D signal from HDBaseT-compliant devices.
Connect an HDBaseT cable.
2.
HDMI I / Dual Pipe Left
HDMI 1.4b input supporting
Frame Sequential
and
Dual Pipe
3D with HDCP 1.4. Also supports the
domestic Blu-Ray formats. See supported signal input
modes on page 107. Connect an
HDMI
cable to the
connector.
3.
DVI-D
Single Link DVI-D input supporting 3D Frame
Sequential up to 30Hz per eye. Also supports the
domestic Blu-Ray formats. See supported signal input modes on page 107.
4.
DisplayPort
DisplayPort 1.1a input supporting
Frame Sequential
3D source up to 120Hz. Connect a
DisplayPort
cable to the connector.
5.
HDMI II / Dual Pipe Right
HDMI 1.4b input supporting
Frame Sequential
and
Dual Pipe
3D with HDCP 1.4. Also supports the domestic Blu-Ray formats. See supported signal input
modes on page 107. Connect an
HDMI
cable to the connector.
6.
Sync In / Sync Out
Sync In is the 3D sync input signal. Connect the 3D sync from your graphics card or server.
Sync Out is the 3D sync output signal. This is affected by settings in the 3D menu such as Dark Time and 3D Sync Offset. Connect this to an IR emitter or
ZScreen.
Rev A June 2019
page 28
Connection Guide
Notes
