Digital Projection DPC 10i, User Manual

Page: 45 / 67

29 Adjustment Menus
䢇
Create MCGD
This is a function for adjusting chromaticity by inputting optical characteristics for your projector.
Please request your dealer/distributor to perform the setting.
䢇
Shutter Mode
The lens shutter function will be activated during the switching of signals.
Please request your dealer/distributer to perform the Setting.
䢇
GPIO Control
Set this control to “Enable” when the engine is to be controlled by the External Control terminal
(GP I/O). With “Enable” set, the projector does not perform engine control.
䡵
Connection
The transmission speed (bps) is selected for your projector and a PC when they are connected by a
commercially available RS-232C straight cable.
Make a selection from among 4800/9600/19200/38400.
䡵
Title Setup
This is for the setting of input signal.
䢇
Title Select
Set an input terminal and various modes for the saved title.
•
Signal Port Select ......... Select an input terminal from among 292-A, 292-B and DVI.
•
Signal Config ................ Please request your dealer/distributor to make this setting.
•
Data File Select ............. Select “PCF” File, “MCGD” File or “Screen” File.
䢇
Title Make
The title of input signal is saved.
Up to 14 alphanumeric characters can be entered.
Up to four titles can be saved in your projector.
䢇
Title Delete
The saved title is deleted.
䢇
Factory Default
The settings are reset to the ones at the shipment of your projector from the factory.
•
All Data ............. Reset all the settings to the ones at the shipment from the factory.
•
Only Title ........... Reset the title settings only to the ones at the shipment from the factory.
䡵
Test Pattern Setup
Use this function to set up the color of test pattern.