Digital Equipment RapidPrint 500, Reference Manual

Page: 160 / 192

Set/Define Service PostScript
11 - 42
11.88 Set/Define Service PostScript
Determines how the RapidPrint 500 will handle PostScript print jobs. If enabled, the RapidPrint
500 will assume there is a PostScript printer attached to the service port(s) and try to ensure a job is
done before starting another. It will send a small PostScript job to the printer before the user data
to “force” the printer into PostScript mode.
At the end of each job it will wait for the printer to signal that the job was completed. If this is not
done, slower printers may lose jobs as new jobs overwrite a previous job which is still being inter-
preted. Enabling PostScript mode is strongly recommended for all PostScript queues.
Restrictions You must be the privileged user to use this command.
See Also Clear/Purge Service ; Show/Monitor/List Services ; Enabling Other Service
Options .
11.89 Set/Define Service PSConvert
Controls whether the RapidPrint 500 will place a PostScript wrapper around each job (enabled).
The RapidPrint 500 will try to detect if it is already a PostScript job, in which case it would not add
an additional wrapper.
See Also Clear/Purge Service ; Show/Monitor/List Services .
11.90 Set/Define Service RTEL
Enables or disables TCP/IP access to the specified service.
Restrictions You must be the privileged user to use this command.
See Also Clear/Purge Service ; Show/Monitor/List Services ; Reverse Telnet (RTEL) .
SET
DEFINE
 
 
 
SERVICE ServiceName POSTSCRIPT
ENABLED
DISABLED
 
 
 
SET
DEFINE
 
 
 
SERVICE PSCONVERT
ENABLED
DISABLED
 
 
 
SET
DEFINE
 
 
 
SERVICE ServiceName RTEL
ENABLED
DISABLED
 
 
 