Digital Electronics Corporation APL3600-TA, Installation Manual

Page: 9 / 18

9
2. Internal switches of the front module
„
Touch Panel Set SW
Switch
Location
Switch Name
Factory
Settings
Description
SW1
Touch Panel
Set SW 1:ON, 2:ON,
3:OFF, 4:OFF 4-point dipswitch. For Touch Panel Set SW
details, see “
„
Touch Panel Set SW”.
SW2 —
1:ON, 2:ON,
3:ON, 4:OFF Internal setting.
Do not change. (Factory setting)
SW1 SW2
ON ON
Rear face of the front module
Switch
No.
Description ON OFF
Factory
Settings
Notes
1 to 2
Internal setting Reserved Reserved
ON
Do not change. (Factory setting)
3 OFF
4
Cancellation function
of two point touch on
the touch panel
*1
Enabled Disabled OFF
The middle point is not considered to be
touched when the SW is ON. It is considered
to be touched when the SW is OFF.
*1 When two points are pushed, it is considered that middle point between the two points is touched
according to the nature of the analog resistive touch panel. When the switch, etc. is set on the middle
point, it will be enabled and may operate. To prevent such a switch from malfunction in case of pushing
two points, turn ON the SW No.4 in advance, then the middle point will be disabled for two point touch.