AirSense
Model 310en Operator’s Manual
Installation
3.20"
1.60"
0.00"
2.10"
1.10"
0.00"
2.00"
2.75"
5.20"
3.50"
0.42"
Figure 1: AirSense Model 310en Mounting Dimensions
Cover Removal
To open the Model 310en use a coin in the slot on the
bottom to release the snap. Lift the cover up slightly to
disengage the closure and remove cover with a downward
motion to clear the catch at the top of the unit.
The locations of controls and terminals on the main circuit
board are shown in the Figure 2 on page 5.
Mounting
The Model 310en is designed for flush mounting with two
fasteners. The locations of the mounting points (shown in
Figure 1) allow direct mounting on a standard simplex
(single circuit) junction box. There is a wiring cutout in the
center of the unit near the terminal strips.
3/9/15
Digital Control Systems
Page:
4
www.dcs-inc.net
•
503/246-8110
