DVM-500Plus Installation Guide 002-0501-02 REV C
Page 18
A CF Memory Card Must Be Installed. Your DVM has been shipped with a 4GB CF memory card. A
memory card must be fully inserted before powering up the unit or a message “Error – CF Missing or
Bad
” will appear on the screen and the unit will fail to start up. Although your CF card is ready to use
out of the box, it should be activated through your back office software. Consult the
DVM-500Plus
User Guide
, and the
VideoManagerII™
or
VuVault™ User’s guides
for information on activating your
CF card.
DO NOT FORCE MEMORY CARDS INTO THE SLOT
The card only goes in one way, with the back side of the card towards the front of the mirror and the
colorful label side facing the back of the mirror. The memory card should slide in very easily and you
should only encounter resistance as the last 1/8” snaps into place. If the card is difficult to insert, pull it
back out and make sure it is facing the right direction and align it carefully with the slot as you reinsert
it.
Important: Do Not Insert or Remove the Compact Flash Card while the Unit
is Powered On.
Important: Before Jump Starting the Vehicle
,
all power should be removed
from the system.
Remove the (2) 7.5 Amp fuses from the side of the I/O Box
BEFORE jump-starting the vehicle. This will prevent potentially damaging
voltage spikes from entering the DVM-500PLUS System. Reinsert the fuses
after jump-starting the vehicle.
POST INSTALLATION CHECKLIST
DVM serial number
Camera serial number
Vehicle Make & Model
Vehicle license plate number
VIN number
Date of Installation
Installer Signature
HOW TO RESET THE DVM-500PLUS SYSTEM
1.
Remove power from the Interface (I/O) Box for 30-60 seconds by removing the (2) 7.5 Amp fuses from
the side of the small, black I/O Box located in the vehicle (location will vary). The I/O Box, DVM, and
the Camera(s) will reset automatically.
2.
Re-insert both 7.5 Amp fuses into the I/O Box and then power up the system by using the MARK
button, or by turning the vehicle’s ignition switch to the ON position (if the DVM was ordered with the
Ignition Power Up option).
