Pag. 5
Digit-KD instruction manual
ENGLISH
4.0. ACCESS CODE
In order to execute the desired function of the Digit-KD, it is necessary to enter an access code
and press a function button.
- The code may be made from of a minimum of 1 digit to a maximum of 4 digits (from 0 to 9).
- There is no limit in the choice of a code: the digits can all the same, or they can be all
different. Example: 2 - 305 - 119 8888 - 4567 etc.
- The control panel can learn and memorize a maximum of 8 different codes.
- For each code you may use an unlimited number of remote keypads.
Enter in programming mode and advance to self-
learning of keys.
The LED “TEST” quickly flashes, while the LED
“LOW BAT.” is lit fixed. On the display appears:
PROG KEY
ch. n. 1 : no
PROG KEY
ch. n. 1 : no
Digit a code (for example 1, 2, 3).
3 asterisks will appear on the
display.
***
PROG KEY
ch. n. 2 : no
MAINT
OK
PROG KEY
ch. n. 1 : si (yes)
Press the button to memorize the code.
A beep is emitted from the control panel
confirming that the code has been learned.
The display shows the message on the
right.
Failure of confirmation on the display that the code has been learned,
indicates that this code is already memorized in another position.
Therefore, repeat operations described in points 2) and 3).
4.1. SELF-LEARNING OF ACCESS CODE
To cancel the codes memorized, press the
button “B” on the control panel.
The keypad displays the message shown
on the right.
To enter a new code in position n. 1 not occupied, repeat the operations 1),
2), 3) and 4).
To move to the next position, press the
button “A” on the control panel and repeat
operations 1), 2), 3) and 4) and so forth up
to the eighth position.
After having memorized the code or codes,
exit programming mode (see control panel
instructions). On the display the message
shown on the right will appear.
