20
Following are the solutions to problems that may occur during the installation and
operation of the
Digisol DG-WU2005V.
1
Why can’t I configure the router even when the cable is plugged and the LED is
lit?
Do a Ping test to make sure that the Wireless
Access Controller is responding.
Go to
Start > Run
.
1.
Type
cmd
.
2.
Press
OK.
3.
Type
ipconfig
to get the IP of default gateway.
4.
Type “
ping 192.168.123.254”.
Assure that you ping the correct IP Address assigned to this
wireless access controller. It will show four replies if you ping correctly.
Ensure that your Ethernet Adapter is working, and that all network drivers are installed properly.
Network adapter names will vary depending on your specific adapter. The installation steps listed
below are applicable for all network adapters.
1.
Go to
Start > Right click on “My Computer” > Properties
.
2.
Select
the
Hardware Tab
.
3.
Click
Device Manager
.
4.
Double-click on “
Network Adapters”
.
5.
Right-click on
Wireless Card bus Adapter
or
your specific network adapte r
.
6.
Select
Properties
to ensure that all drivers are installed properly.
Note:
It is recommended that you use
an Ethernet connection to configure
it
