DG-PE1148D Quick Installation Guide
DG-PE1148D Quick Installation Guide
DG-PE1148D Quick Installation Guide
Rev. 3.0 Copyright 2018 by Digisol Systems Ltd. All rights reserved
Hardware Installation
Step1: Connect one end of the power cord to the AC power outlet
and the other end to the Power connector on the device.
DG-PE1148D
Step2: Connect CAT5/5e/6 cable from LAN or a switch to “LAN”
port on DG-PE1148D.
Step3: Connect CAT5/5e/6 cable from PoE enabled device (e.g.
PoE IP camera or a PoE Access point) to the “PoE” port on DG-
PE1148D.
Technical Specifications
• Hardware Specifications
One Power Connector
One 10/100 Mbps Ethernet LAN Port
One 10/100 Mbps Ethernet PoE Port
• Standards Compliance
IEEE802.3 10Base-T Ethernet
IEEE802.3u 100Base-TX Fast Ethernet
IEEE802.3af/ IEEE802.3at Power over Ethernet (PoE)
• Ethernet Pin Usage
Data: Pin No. 1,2,3,6
Power: Pin No. 4 & 5 (V+), 7 & 8 (V-)
• LED Indicator
Power
• Data Transfer rates
100 Mbps Half-Duplex
200 Mbps Full-Duplex
• Network Cables
100Base-Tx: UTP Cat5/5e (100m)
• Power
Input: AC 100~ 240V, 50~ 60Hz
PoE Out:48V DC, 0.5A
• Environmental Specifications
Operating Temperature: -10º C to 40 º C
Storage Temperature: -30 º C to 80 º C
Operating Humidity: 10% to 95%
Storage Humidity: 10% to 95%
• Dimension
Net: 115(L) x 54 (W) x 35 (H)mm
• Weight
Net: 160gms
Frequently Asked Questions
Following are the solutions to problems that may occur during the
installation and operation of the Digisol DG-PE1148D PoE
injector.
The Power LED on DG-PE1148D is OFF
• Ensure that the DG-PE1148D is connected to an AC
power outlet using the power cord shipped with the
product.
• Connect the power cord firmly to the power connector
on the device.
The PoE enabled device does not power on
• Verify that the PoE device which needs to be powered
on is connected to the “PoE” port of DG-PE1148D
• Ensure that the PoE device is connected firmly to
DG-PE1148D.
• Try using another CAT5/5e cable.
• Verify the Max. power consumption of the PoE enabled
device and whether it complies with IEEE802.3af / IEEE802.3at
standard.
1. Can DG-PE1148D work with any PoE enabled device?
• DG-PE1148D can power on any PoE enabled device
that complies with IEEE802.3af/ IEEE802.3at standard.
If you still encounter problems or have any questions regarding
the PoE injector Installation/Troubleshooting, please contact
Digisol Technical Assistance Centre.
This product comes with one year warranty. To avail &
activate warranty for your product. kindly register your
product by calling us @18002093444
Your Installation is now complete
