Digisol DG-FS4528P, Management Manual

Page: 476 / 973

C
HAPTER
22 | System Management Commands
Line
– 476 –
password-thresh
This command sets the password intrusion threshold which limits the
number of failed logon attempts. Use the no form to remove the threshold
value.
S
YNTAX
password-thresh [ threshold ]
no password-thresh
threshold - The number of allowed password attempts.
(Range: 1-120; 0: no threshold)
D
EFAULT
S
ETTING
The default value is three attempts.
C
OMMAND
M
ODE
Line Configuration
C
OMMAND
U
SAGE
When the logon attempt threshold is reached, the system interface
becomes silent for a specified amount of time before allowing the next
logon attempt. (Use the silent-time command to set this interval.) When
this threshold is reached for Telnet, the Telnet logon interface shuts down.
E
XAMPLE
To set the password threshold to five attempts, enter this command:
Console(config-line)#password-thresh 5
Console(config-line)#
R
ELATED
C
OMMANDS
silent-time (476)
silent-time
This command sets the amount of time the management console is
inaccessible after the number of unsuccessful logon attempts exceeds the
threshold set by the password-thresh command. Use the no form to
remove the silent time value.
S
YNTAX
silent-time [ seconds ]
no silent-time
seconds - The number of seconds to disable console response.
(Range: 0-65535; 0: 30 seconds)
D
EFAULT
S
ETTING
The default value is no silent-time.