DigiSender Plug’n’Go DX200-LCDRX, Instruction Manual, Page: 2 / 8

Please read this instruction manual carefully prior to installation Page 02
DX200-LCDRX - DigiSender® Plug’n’Go™ LCD
Step 1: Install the Accessory Receiver
Connect the Receiver into a Mains Extension
Lead.
The positioning of the Receiver can affect
the picture quality so being able to move it is an
advantage.
2.
The Plug’n’Go™ LCD Accessory Receiver will pick up the signals being sent by your Plug’n’Go™ LCD
Transmitter and output them to a connected TV.
Press and hold the power button for 5 seconds to
turn the Receiver on.
Pressing the button again
cycles through the 4 available channels. Make sure
it is set to the same channel as the Transmitter.
3.
Locate a vacant SCART socket on the back of your
receiving TV and insert the DigiSender® SCART
cable.
1.
Position the IR Sensor on the top, side or bot-
tom of your receiving TV with the lens facing
out into the room.
4.