WebColour - Web Based LED Control
User Manual
7.0 - 23 November 2020
Page 12 of 25
+617 3899 1267
System
Unit Name
The unit name has several uses in the system. But most
notably, it is used as a NetBIOS name, and it will also display
as the title on the page.
Power Up State
This option sets what the WebColour will do when it is
powered up. Options are:
1.
Turn LEDs off
2.
Turn LEDs on (load last settings)
3.
Turn LEDs on, load favourite 1 through 10
In the case of turn on, the unit will load the last saved
settings. Settings are automatically saved 5 minutes after
they are changed.
Network Settings
By default, the WebColour has DHCP enabled. It is highly
recommended that as part of initial configuration, the DHCP
is disabled and a static IP address is set. This will prevent the
unit from changing IP addresses at a later point, making for
easier access from non-NETBIOS devices (such as phones and tablets)
To set a static IP address, it is normally only necessary to change the last digit of the IP address, leaving the
Netmask and Gateway as it was set by DHCP.
Output Mode
The Mode option select if the WebColour is outputting control for RGB (3 channels) or RGBW (4 channels).
If RGB is selected the output on the fourth channel is turned off.
Versions
At the bottom of the System configuration page are the UI version and Firmware version numbers. Note
that these will not necessarily match.
DMX Format
The DMX model outputs 4 channels of DMX data, in the DMX address range 1 through 4 (these being used
for red, green, blue and white respectively). If operating in RGB mode, the 4
th
channel (white) is transmitted
as 0 (off).
Figure 9. System Settings Configuration page
