Edge 20 - LED Lighting Profile
Installation Guide
digilin.com.au
+617 3899 1267
Page 2 of 2
Installation
1.
Connect power and feed cables as required.
2.
Secure the lower extrusion (mounting tray)
into position using appropriate fasteners
(head height of no more than 3.5mm). Take
care no to place a screw directly below the
cable entry point.
3.
Press the main extrusion into the mounting
tray.
4.
Replace the end cap where applicable.
5.
Turn on Power
Note: Drivers should not be covered. Drivers rely on convection air flow for cooling and covering them may cause them to enter thermal regulation.
For any technical information relating to the connection of these luminaires to dimming systems, refer to LED products at
