Digikeijs DR5088RC DIGIDETECT, Manual

Page: 20 / 43

DR5088RC DIGIDETECT
30.05.2019
P 20
www.digikeijs.com
4.1 Properties Loconet
1) Slow module timing. Can be activated for problems with Loconet components from other manufacturers.
2) Baudrate tuning. Used to adjust the exact baud rate in Loconet. *
3) Komperator tuning. Here the edge steepness and the edge height can be adjusted. *
4) RailCom Report. Here you can select the LocoNet commands with which the RailCom message is to be sent.
MULTI_SENSE_Standard The original OPC_MULTI_SENSE command is used (Digitrax and Bluecher compatible).
The address ranges "locomotive address or block address" are restricted if the derailment direction is to be sent.
MULTI_SENSE_Long The new OPC_MULTI_SENSE_L command is used: No restriction of the address ranges.
MULTI_SENSE_Both Both commands (Long and Standard) are transmitted to the central unit.
5) RailCom Sense direction. Here you select how the derailment direction is reported to the control centre in the case of "MULTI_SENSE_Standard.
Aus No direction is transmitted.
in Blockadress The track-laying direction is transmitted in the block address (restriction of the block addresses to a maximum of 2048).
in Lokadress The track-laying direction is transmitted in the locomotive address (restriction of locomotive addresses to a maximum of
4095).
1
2
4
5
3
*Note! Only experienced users should make changes here.
to make a decision.