23
5.2.7. RECEIVER UPGRADE - OAD
Over Air Download (OAD):
To ensure that
your STB always has the most up todate
information. Please ensure that after use it
is set to its standby mode. The STB
automatically powers up at 3.00 A.M. each
day and searches for any new information
which may be broadcast and will download
this to your receiver automatically. This
operation will normally take approximately
30 minutes. If you have an important
recording to make at 3.00 A.M. which must
not have a 30 minutes interrupt then you
can disable the auto OAD search by
performing the following:
Ø
Press Menu button and using the
“
5
/
6
” buttons to choose Setup
and press the OK button.
Ø
Highlight Configuration menu with “
5
/
6
” keys and pres OK.
Ø
Use “
5
/
6
” buttons to choose "RECEIVER UPGRADE" and press OK button.
Ø
Using the left / right button change “Automatic scanning” from Enabled to Disabled.
Ø
Highlight “Scan for upgrade” menu with “
5
/
6
” keys and pres OK to commence upgrade.
Do not forget to re enable the automatic OAD function after you have made your recording by
repeating the above instructions but this time selecting ENABLE.
5.2.8. PARENTAL LOCKING
Use “
5
/
6
” buttons to go to Parental Lock option.
Press OK button to enter the menu. A box asking for
the lock key is displayed. The key is set to “0000”
initially. Enter lock key. If it is incorrect, "Wrong Pin"
is displayed. If it is correct, the Parental Control
Menu is displayed.
5.2.8.i. MENU LOCK
In menu lock you can set locking for All Menus, or the Installation Menu to restrict access to these
menu's. If the menu lock is disabled, there will be free access to the menu system. Use “
5
/
6
” buttons
to go to Menu Lock option. Use “
3
/
4
” buttons to choose Menu Lock Mode.
DISABLED :
All menus are unlocked.
ALL MENUS :
All Menus are accessible only with the correct lock key.So the user can’t add, delete,
rename, channels, can’t set timers.
INSTALLATION MENU :
Installation menu is locked.So the user can’t add channels. Changes will be
updated after exiting ‘Configuration Menu’.
5.2.8.ii. SET PIN
The PIN code of the unit changed. Use “
5
/
6
”
buttons to go to “Set PIN” option. Press OK to
display the “Set PIN” window. Use NUMERIC
buttons to enter new pin number you will need to
input your new pin a second time for verification
purposes. If Both pin numbers are four digits long
and the same, the pin will be changed. The factory
default pin number is 0000, if you change the pin
number make sure you write it down and keep it safe.
