Digigram LoLa16161, User Manual

Page: 5 / 33

LoLa881
​ ​
&
​ ​
LoLa16161
User
​ ​
manual
INFORMATION
​ ​
FOR
​ ​
THE
​ ​
USER
This device complies with part 15 of FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may ​ ​ cause ​ ​ undesired ​ ​ operation.
This equipment has been tested and found to comply with the limits for a CLASS
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions contained
in this data sheet, may cause harmful interference to radio and television
communications. However, there is no guarantee that interference will not occur
in ​ ​ a ​ ​ particular ​ ​ installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
*
​ ​ reorient ​ ​ or ​ ​ relocate ​ ​ the ​ ​ receiving ​ ​ antenna
* ​ ​ increase ​ ​ the ​ ​ separation ​ ​ between ​ ​ the ​ ​ equipment ​ ​ and ​ ​ the ​ ​ receiver
* ​ ​ connect ​ ​ the ​ ​ equipment ​ ​ into ​ ​ an ​ ​ outlet ​ ​ on ​ ​ a ​ ​ circuit ​ ​ different ​ ​ from ​ ​ that ​ ​ of ​ ​ the
receiver
*
​ ​
consult
​ ​
the
​ ​
dealer
​ ​
or
​ ​
an
​ ​
experienced
​ ​
audio
​ ​
television
​ ​
technician.
Note: Connecting this device to peripheral devices that do not comply with
CLASS
​ ​
B requirements or using an unshielded peripheral data cable
could ​ ​ also ​ ​ result ​ ​ in harmful interference to radio or television reception.
The
​ ​
user
​ ​
is
​ ​
cautioned that any changes or modifications not
expressly
​ ​
approved
​ ​
by
​ ​
the
​ ​
party responsible for
compliance could void the user’s authority to operate this equipment. To
ensure that the use of this product does not contribute to interference, it
is ​ ​ necessary ​ ​ to ​ ​ use ​ ​ shielded ​ ​ I/O ​ ​ cables.
Warning:
Electrostatic discharge (ESD) can damage several
components on the board. To avoid such damage
in handling the board, take the following
precautions:
Bring the device and everything that contacts it to
ground potential by providing a conductive surface and discharge paths. As a
minimum,
​ ​
observe
​ ​
these
​ ​
precautions:
● Disconnect
​ ​
all
​ ​
power
​ ​
and
​ ​
signal
​ ​
sources.
5