LEONARDO 56
Modem AT Command Set
3.5
ATW
REPORT AT CONNECTION
W0
When connected the modem displays:
CONNECT and the digital rate.
W1
When connected the modem displays:
Line Speed,Error Correction Protocol (if any),Digital rate
W2
When connected the modem displays:
CONNECT and line speed.
ATX
DIAL TONE DETECTION
X0
Busy and dial tone detect disable. OK and ERROR code enable.
X1
Busy and dial tone detect disable. OK and CONNECT xxxxx code
enable.
X2
Dial tone enable only. OK, NO DIAL TONE and CONNECT xxxxx
enable.
X3
Busy tone enable only. OK, BUSY and CONNECT xxxxxx enable.
X4
Busy and dial tone enable OK, BUSY, NO DIAL TONE and
CONNECT xxxxx enable.
ATY
BREAK DISCONNECTION
Y0
Disable long space disconnect.
Y1
Enable long space disconnect. In non-error correction mode or in
buffer mode, the modem will send a long space of four seconds
prior to going on-hook. In error correction mode, the modem will
send respond to the receipt of a long space (a break signal greater
than 1,6 seconds) by going on-hook.
ATZ
RESET AND LOAD USER PROFILE
Z0
Reset and load user profile 0.
Z1
Reset and load user profile 1.
AT+MS= MODULATION FORMAT
This extended-format command selects the modulation, optionally enables
or disable automode, and optionally specifies the lowest and highest rates
using one to four subparameters. the command format is:
AT+MS=[mod],[automode],[min_rate],[max_rate]
# [mod]
= modulation type
# [automode]
= automode enable or disable
# [min_rate]
= min line speed
# [max_rate]
= max line speed
l
Modulation type (see the below table)
Summary of Contents for Leonardo 33.6
Page 35: ......
