Digi XBee 3 802.15.4, User Manual

Page: 133 / 264

AT commands Coordinator/End Device configuration commands
Digi XBee® 3 802.15.4 RF Module User Guide 133
Parameter Configuration ACKs
0 Digi mode With ACKs
1 802.15.4 No ACKs
2 802.15.4 With ACKs
3 Digi mode No ACKs
Default
0
NP (Maximum Packet Payload Bytes)
Reads the maximum number of RF payload bytes that you can send in a transmission.
NP is based on multiple factors including the length of the source address, the length of the
destination address, the length of the APP header, and whether or not encryption is enabled.
For the purposes of this command, it always assumes a long destination address. This means that if
you select a short destination address, you will be able to send up to
NP + 6 bytes in a single packet.
Note NP returns a hexadecimal value. For example, if NP returns 0x66, this is equivalent to 102 bytes.
Parameter range
[read-only]
Default
N/A
Coordinator/End Device configuration commands
The following commands configure the device for a master/slave 802.15.4 network.
CE (Coordinator Enable)
The routing mode of the XBee 3 802.15.4 RF Module.
The XBee 3 802.15.4 RF Module does not allow association until bit 2 of A2 (Coordinator Association) is
set.
Parameter range
0 - 1
Parameter Description
0 End Device
1 Coordinator
Default
0