Digi TX54, User Manual

Page: 618 / 1087

Services Location information
TX54 User Guide 618
(config service location geofence test_geofence on_exit
action 0)> max_memory 1MB
(config service location geofence test_geofence on_exit
action 0)>
v. A sandbox is enabled by default to prevent the script from adversely affecting
the system. To disable the sandbox:
(config service location geofence test_geofence on_exit
action 0)> sandbox false
(config service location geofence test_geofence on_exit
action 0)>
If you disable the sandbox, the script may render the system unusable.
vi. Repeat for any additional actions.
7. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Show location information
You can view status and statistics about location information from either the WebUI or the command
line.

WebUI
1. Log into the TX54 WebUI as a user with Admin access.
2. On the main menu, click Status .
3. Under Services , click Location .
The device's current location is displayed, along with the status of any configured geofences.

Command line
Show location information
1. Log into the TX54 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. Use the show location command at the system prompt:
> show location
Location Status