Digi TransPort WR11, User Manual

Page: 655 / 866

Configure system settings General system parameters
Digi TransPort WR Routers User Guide 655
General system parameters
The General system parameters page has the following settings.
Autorun Commands
The router can be configured to run a number of commands once it has booted. These commands
are associated with specific asynchronous serial interfaces. For example, suppose a Script Basic
script, sample.bas , must be run at boot up. Autorun commands are normally associated with an
ASY port, but running a script for example is not ASY port-specific.
To configure the autorun commands, set the following values:
#
The command interface to be associated with the command. In the above example, this would
be set to the number 0 .
Command
The CLI command to run on start-up. In the above example, this field would be set to the string
bas sample.bas .
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
cmd n autocmd Valid CLI command Autorun Commands