Wi-Fi
Configure a Wi-Fi access point with enterprise security
LR54 User Guide
284
2. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
3. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Configure a Wi-Fi access point with enterprise security
The WPA2 enterprise security mode allows a Wi-Fi access point to authenticate clients by using one or
more RADIUS servers. When the Wi-Fi access point receives a connection request from a client, it
authenticates the client with the RADIUS server before allowing the client to connect.
Using enterprise security modes allows each client to have different usernames and passwords
configured in the RADIUS server, rather than using preshared key on the LR54 device.
By default, the LR54W device comes with two preconfigured access points,
Digi AP (Wi-Fi1)
and
Digi
AP (Wi-Fi2)
. You cannot delete default access points, but you can modify them or you can create your
own access points.
Required configuration items
n
Enable the Wi-Fi access point
n
Select a Wi-Fi radio for the access point.
n
The Service Set Identifier (SSID) for the access point.
n
Configure security for the access point to WPA2 enterprise.
n
The IP address for one or more RADIUS servers.
n
The secret key for one or more RADIUS servers.
n
LAN/bridge assignment. Once you configure a Wi-Fi access point, you must assign the Wi-Fi
access point to a LAN interface or to a bridge. See
Configure a Local Area Network (LAN)
and
for more information.
Additional configuration items
n
Determine whether to broadcast the access point's SSID.
n
Determine whether to isolate clients connected to this access point, so that they cannot
communicate with each other.
n
The server port for one or more RADIUS server.
n
The amount of time to wait before changing the group key.
To configure a Wi-Fi access point with WPA2 enterprise security:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
