Digi Connectware RealPort, Setup Manual

Page: 21 / 22

RealPort Setup
3-11
fastbaud Data Rate Mapping
Use the table below to see how setting fastbaud affects RealPort data rates.
onstr " s " Defines the terminal escape sequence to direct subsequent data to the
transparent printer.
s is a string of ASCII characters, enclosed in quotes, that command the terminal
to enter transparent printing mode. An arbitrary octal character xxx may be
given as \xxx.
For example, the sequence <Esc>[5i would be entered as:
"\033[5i"
.
offstr " s " Defines the terminal escape sequence to stop directing data to the printer.
s is a string of ASCII characters, enclosed in quotes, that command the terminal
to enter transparent printing mode. An arbitrary octal character xxx may be
given as \xxx.
For example, the sequence <Esc>[5i would be entered as: "
\033[5i
".
term t Sets the transparent printer on/off strings to values found in the internal default
table. Internal defaults are used for the following terminals: adm31, ansi, dg200,
dg210, hz1500, mc5, microterm, multiterm, pcterm, tvi, vp-a2, vp-60, vt52,
vt100, vt220, wyse30, wyse50, wyse60, or wyse75. If the terminal type is not
found in the internal default table, then ditty reads the terminfo entry for the
terminal type and sets transparent print on/off strings to values given by the
mc5/mc4 attributes found there.
Specified Data Rate: Data Rate Mapped to:
50 57600
75 76800
110 115200
134 131657
150 153600
200 230400
300 460800