91001108B
Activating Port Changes
Web Management Interface
To immediately activate port parameter changes using the Web Management Interface,
do the following:
1.
Go to the Administration section of the navigation bar, choose Restart Processes.
2.
Choose Stop digi_ras. After a pause, the Status field changes from Active to
Inactive, and the text on the button changes to Start digi_ras. If it does not, repeat this
step.
3.
Choose Start digi_ras. The changes are complete.
Command Line Interface
To immediately activate port parameter changes using the command line interface, enter
the following command from the root prompt:
signal_ras hup
The changes are complete.
Copyright
The Digi logo and PortServer CM are registered trademarks of Digi International. All other brand and product
names are trademarks of their respective holders.
© 2002 Digi International Inc. All Rights Reserved.
Information in this document is subject to change without notice and does not represent a commitment on the
part of Digi International. Digi provides this document “as is”, without warranty of any kind, either expressed
or implied, including, but not limited to, the implied warranties of fitness or merchantability for a particular
purpose. Digi may make improvements and/or changes in this manual or in the product(s) and/or the pro-
gram(s) described in this manual at any time.
This product could include technical inaccuracies or typographical errors. Changes are periodically made to
the information herein; these changes may be incorporated in new editions of the publication.
PortServer CM
Setup Guide
Introduction
The PortServer CM
™
is a Linux based secure console access server. It runs an
embedded version of the Linux operating system making the configuration process
very familiar for UNIX and Linux users. The addition of a browser-based Web
Management Interface makes the configuration of the PortServer CM much easier for all
users. This setup guide gives the basic information needed to get the PortServer CM up
and running in a minimal amount of time.
Additional information about the product, such as Frequently Asked Questions and
firmware upgrades, are available at the Digi PortServer CM website, http://cm.digi.com.
What’s in the Box
Before you begin the installation and configuration procedure for the Digi device, you
should have: