Installation Instructions
Garage Door Opener Radio Controls
Model 5060\5061 (300 MHz) - 5062\5063 (310 MHz)
Two Button Transmitters
SECTION #1
SETTING THE CODE SWITCHES
Your Digi-Code radio controls are designed specifically to remotely control a garage
door opener from within an automobile and to give years of trouble free service without
adjustment.
Because all radio controls are set with the even numbered switches in the
“ON” Position when they leave the factory, it is recommended that a different code
be selected and set at the time of installation.
Please refer to the “Setting the Code
Switches” section for instructions. The radio frequency (RF) portion of the controls,
however, are tuned to standard frequencies and are thoroughly tested at the factory. This
permits the addition or replacement of either the transmitter or the receiver by specifying
the Model number and the RF frequency designated on the identification label. RF
adjustments are not needed nor should any be attempted.
WARNING:
• Disconnect operator power before any installation or repair
• Always wear safety glasses
On the transmitter the entire front lower half of the case (“the battery hatch”) is
removeable. Use a coin or the curved end of the visor clip to disengage the lower half of
the transmitter front. This will expose both the code switch and the battery compartment.
( SEE FIGURE #1 )
2.
Replacing the transmitter battery.
If, after performing the above operational checks, the controls still do not function, they
should be returned to your dealer for repair or replacement.
WARRANTY
All Digi-Code door related products carry an eighteen (18) month warranty against
defects in workmanship or material. This warranty begins at the date of manufacture, for
eighteen months. Digi-Code warrantees our product only to our authorized dealers and
distributors, and not to the end customer. If you have any questions about our warranty,
please ask your dealer to determine the nature and scope of their warranty. Digi-Code
does not assume, and is not responsible for, any real or consequential damages from
claims against the performance of our product, nor is it liable for any costs related to the
loss of life, property, or revenue. Further, Digi-Code is in no way responsible for
installation of our product, and will assume no cost related to reinstallation or removal.
Digi-Code’s warranty is in lieu of all other warrantees, expressed, or implied.
CAUTION:
Any changes or modifications in intentional or unintentional radiators which
are not expressly approved by Digi-Code Inc. could void the users authority to operate this
equipment. This applies to intentional and unintentional radiators certified per part 15 of
the FCC rules and regulations.
DIGI-CODE, INC.
Part # 72-5060B
