PRELIMINAR
Y
7
E
230V
115V
1.5 Mains voltage setup
Warning: before removing the cover, turn off the power switch; unplug the mains cable and wait for 10 minutes.
The Digam L series accepts 115V or 230V mains voltage. To set up the correct voltage unscrew the screws on the top and
on the lateral side of the unit and remove the cover and plug the small cable showed in the figure 1.5.1 to the correct male
faston; then reset the cover and plug the mains cable.
figure 1.5.1
1.6 Building and setting DSP module(s)
Warning: before removing the cover, turn off the power switch and unplug the mains cable.
The Digam L series has otional DSP modules for additional sound effects. To mount or unmount theDSP modules remove
the cover; you can mount this modules on the 72-pin SIMM sockets as showed in the figure below.
DSP socket for CH1 and CH2 channel
DSP socket for CH3 and CH4 channel (only for LQ model)
DSP modules
SW302 DIP SWITCH
(only for LQ model)
SW103 DIP SWITCH
(only for LD model)
SW102 DIP SWITCH
SW104 DIP SWITCH
figure 1.6.1