DieHard 28.71486, Operator'S Manual

Page: 8 / 12

•
5
•
GROUnDInG AnD AC POWER CORD COnnECtIOnS 4.
RISK OF ELECtRIC SHOCK OR FIRE.
The jump starter internal charger plug is for use on a nominal 120-volt circuit. 4.1
The extension cord utilized with the internal charger plug must be plugged into
an outlet that is properly installed and grounded in accordance with all local
codes and ordinances. The plug pins must fit the receptacle (outlet). Do not
use with an ungrounded system.
ASSEMBLY InStRUCtIOnS 5.
Remove all cord wraps and uncoil the cables prior to using the jump starter.
FEAtURES 6.
Jump start ON/OFF Switch 1.
Power Switch 2.
Indicator LEds 3.
Built-In Light 4.
Charger Plug 5.
12v Accessory Plug 6.
1
2
3
4
6
5
CHARGInG tHE IntERnAL BAttERY OF tHE JUMP StARtER 7.
IMPORtAnt: CHARGE IMMEDIAtELY AFtER PURCHASE, AFtER EACH
USE AnD EvERY 30 DAYS tO KEEP tHE JUMP StARtER IntERnAL
BAttERY FULLY CHARGED.
LED Indicators:
7.1
To check the internal battery’s charge status, toggle the Light/display switch to
the dISPLAY position.
The LEd lights will indicate the charge level as follows:
A red LEd indicates a 50% or less charge and you should immediately •
recharge the jump starter.
A yellow LEd indicates a 50 to 75% charge. The jump starter may be used
•
but should be recharged as soon as possible.
A green LEd indicates the internal battery is fully charged.
•
The CHARgINg (red) LEd indicates the jump starter is charging •
(connected to an AC power source.) At full charge, the FULL (green) LEd
will light.