Maintenance
and
Repair
© Diebold Election Systems, Inc. 2002 AccuVote-OS Hardware Guide
34
4) Thread the deflector cable between the ballot chute and the ballot box lid, behind the power
cord tube and down towards the deflector motor.
5) Pull the cable tight and connect to the deflector motor cable.
6) Position the deflector connector bracket with the screw holes lining up with those in the ballot
box lid. Insert the screws using a Philips (+) screwdriver.
7) Thread the nuts onto these screws on the inside of the ballot box lid. Tighten the nuts by fixing
the screws with the Philips (+) screwdriver in one hand and a 5/16” nut driver in the other.
8) Attach the cable with a tie strap to the right hand side of the ballot deflector.
9) Attach the cable with a tie strap to the power cord tube.
10) Attach the cable with a tie strap to the motor mount bracket.
11) Once the deflector cable is in place, replace and lock the security plate into the ballot entry
slot.
12) Remove the lift arm from the ballot box lid and close and lock the ballot box.
