DIEBOLD NIXDORF BEETLE/M-III, Operator'S Manual

Page: 21 / 74

9
9 Connecting orifice plate
9.1
9.1 Power supply unit
The installed power supply unit automatically adjusts itself to the respective voltage.
CAUTION
Only a power supply unit approved by Diebold Nixdorf may be used to replace the power
supply unit.
CAUTION
The device must be fully disconnected from the supply voltage when performing any work
at the device and when plugging in or disengaging data cables. To completely disconnect
the appliance from the supply voltage, switch off the device and pull out the power plug of
the power supply unit.
1 PoweredUSB 24 V 2 RJ12 (cash drawer)
3 Power plug
9.1.1
9.1.1 PoweredUSB 24 V
USB peripherals which are operated with a higher energy requirement than through a standard USB,
e.g. printers, barcode scanners or displays, can be supplied with electricity via a PoweredUSB. The
power supply is 24 V (marked in red for POS printers).
A mechanical coding prevents a PoweredUSB 12 V or a 5 V plug from being accidentally plugged into a
PoweredUSB 24 V socket. PoweredUSB ports can also be used as USB-A sockets.
01750341829F 9-1