© DICTATOR Technik GmbH • Gutenbergstr. 9 • 86356 Neusäß • Germany
Tel. +49(0)821-24673-0 • Fax +49(0)821-24673-90 • E-mail [email protected] • 1067
Electromagnets
Page 07.032.00
ø 40
23
ø 60
ø 48
67
10
7
ø 96
88
"L"
"M"
8
8
70
68
7 x 1
0
3
40
ø 1
8
Ar
re
tierschr
aube
You can either fix the electromagnet with swivel head to the floor, ceiling or wall. If you
want to change the position of the head, you need to loosen the locking screw and turn
the head by 90°.
If you need to cut the distance tube, remove the head after loosening both grub screws
which fix the head to the tube. Then pull out the wires connected to the interruption key.
An anchorplate needs to be fixed to the door as a counterpart to the magnet. A choice
of different counter plates can be found later in this section.
The connection wires are inserted through an opening in the mounting plate. After the
magnet has been properly mounted and wired, both plastic covers are pushed from the
side over the mounting plate and clipped into position.
Please note:
It must be possible to release a fire protection door held open by an electromagnet with
a hand switch which is not hidden by the opened door. (DICTATOR hand switch part no.
040005, see diagram on the left).
Installation
Order Information
Dimensions
Locking screw
Model
Force
Length "L" Height "M" Part no.
GD 60 S 175
700 N
175 mm
107 mm
040111
GD 60 S 175 oT (ohne Taster =
without interruptor key)
700N
175 mm
107 mm
040264
GD 60 S 175 S
1000 N 175 mm
107 mm
040164
GD 60 S 325
700 N
325 mm
257 mm
040112
GD 60 S 475
700N
475 mm
407 mm
040113
