Setting the Temperature
This Menu item is
only available and displayed if temperature controlled vaping is
selected
(see Heater-Control menu item below).
The Temperature Up/Down menu sets the coil temperature during vaping. The temperature can be set from
120°C to 280°C (250°F- 540°F) in steps of 5°C (10°F). It’s necessary to perform a reference measurement
(TemCal Init) To achieve precise temperature control.
Manual Coil Temperature Calibration
This Menu item is
only displayed if temperature controlled vaping is selected
(see
Heater Control menu item below). Temperature calibration is a very important step in
achieving optimum results during Temperature Controlled Vaping.
The Temperature Calibration function measures the coil resistance at room temperature (20°C) as the
reference for temperature controlled vaping. This measurement of resistance combined with the wire’s
temperature coefficient enables the mod to calculate the coil’s temperature.
The calibration must be confirmed to avoid accidental adjustments. After confirmation the display shows
“process” until the calibration is completed. If the calibration is performed at a temperature other than
20°C, the device will regulate a constant temperature,
but with an offset deviation
. So take the ambient
temperature during calibration into account. Similarly, if an incorrect coefficient is used, the actual
temperature might deviate dramatically from the desired temperature.
Always perform a calibration when a new atomizer is attached, even if the coil is made from the same
material as the previous one.
For further information about this topic, please read the “Application Note for Temperature Controlled
Vaping”, on the dicodes-mods website.
Coil Resistance and Coil Temperature
The coil resistance is displayed in a range from
0.00 to 9.90 Ohms. If Temperature Controlled vaping is selected, the current measured
coil temperature is also displayed. If TC mode is not selected, the display shows T ---.
If the display does not show 20°C even with a cooled-down atomizer, it is recommended that the user
perform a manual calibration.
NOTE: For coils with very low resistance, like Nickel-coils, a slight mechanical rearrangement (tightening
the atomizer) can lead to drastic changes in temperature due to changes in contact resistances. We
recommend the use of coils made from more than just nickel e.g. the NiFe30 (RESISTHERM) wire from
dicodes.
Battery Status
The Check Battery item shows the battery voltage (Ub0) and the battery voltage under
load during the last puff (UbL). The difference is the voltage drop of the battery. A high
drop (>0.4V) indicates a weak battery or contact problems.
Please note that every battery has an inner resistance and the voltage at its contacts always drops when
current is drained. The more current drained, the higher the drop. 18650 batteries have inner resistances
from about 15mOhm up to 80mOhm. Smaller sized batteries even have higher resistances. Generally
speaking, batteries with high capacity have higher inner resistance and those with lower capacity have
lower inner resistance.
05 Main Menu (Page 2)
Summary of Contents for Dani Box
Page 1: ...Dani Box manual ...
