Page | 4
4)
The Add Receiver window will open. Enter the last 4 digits of Receiver’s serial number as the ID.
Note: 0000 and FFFF are not valid IDs. Do not start an ID with lead zeros (eg. 0001).
Click Save Changes.
A window will appear confirming that Receiver Configuration is Complete. Click Close
At the lower left hand corner of the WiZARD2 software screen. You will see the following status:
Connection to Broker: Connected | Connection to Receiver: Connected
The service is running and the Receiver is recognized by the service.
Setup and installation of the software and Receiver is complete. Keep the receiver connected. Continue to
“Adding Repeaters” if you have purchased any Repeaters, otherwise skip to “Adding Loggers” to setup
Loggers.
Summary of Contents for WiZARD2
Page 1: ...DICKSON WiZARD2 Manual Rev 1 2 0 12 112311...
Page 21: ...Page 21...
