Dick SM-200 TE, Operating Instructions Manual, Page: 36 / 76

SM-200 TE Grinding and Honing Machine 36
Setting up the Machine
8
8.4 Setting the cooling water supply
Set the cooling water supply hose for the grinding task. Set the
cooling water supply so that sufficient water reaches the grinding
wheel and the hose does not impede the grinding process.
1 Set the On/Off switch for the abrasives to position 0 (OFF).
2 Set the On/Off switch for the cooling water to position I (ON).
3 Close the valve [2] .
4 Set the hose [1] so that the water can run onto the grinding
stone without impeding the grinding process.
5 Open the valve again and check the result of the adjustments.
6 Set the On/Off switch for the abrasives to position I (ON).
Figure 8.3 – Cooling water supply
[1] Hose
[2] Valve
2
1