6
7
III. How to charge:
1) When only one indicator light is blinking, please turn off the appliance, put it back to
the charging base, then make sure the plug of the charger has been inserted into the
socket. When charging, the indicate lights will become flashing green.
Note： How to use the wall bracket
1. Hang it on the wall with screws
2. Use 3M stickers to make the bracket glued to the wall, for storing the vacuum cleaner
(make sure the height is the same as the vacuum cleaner itself, totally hanging away
from floor is not acceptable)
2) It will have 3 green lights on after fully charged.
IV. How to Maintain the Filter:
How To Use
Troubleshooting
1）Press the handle locker to
remove the battery from dust cup.
3）Take out the filter case, then
take out the filter.
5）Please dry the filter and the filter case
completely before assembling back.
7）Put the filter case back to the
dust cup.
※Troubleshooting:
※Technical Specification:
8）Assemble the top cover to the
dust cup.
6）After drying, assemble the filter
to the case.
4）Wash the filter case and the
filter by water.
2）Separate and remove the top cover
as showed below.
Suction gets weak
1, Empty the dust cup
2, Check if the dust cup is installed correctly
3, Check if the filter case and the filter are installed
correctly
4, Clean the filter
Stop working
1, Charge the vacuum
2, Clean the roller brush and the bearing thoroughly
Battery doesn’t hold
a charger
1, Check if the plug has been inserted already
2, Check if the socket is useful
Battery
22.2V/2200mAh
Charging time
4-5 hours
Battery charger input
100-240V ~ 50/60Hz 0.3A
Battery charger
output
26V 0.45A
Working time
45min(low speed), 25min(high speed)
Power
120W
Largest Suction
9KPa
4-5
hours
Blinking
Charging port
Wall
