23
TROUBLESHOOTING
Symptom
Cause and Check
Solution
E00
Safety Key not in the position
Re-locate the safety key in the correct position
E01
No signal to Controller from
console
A: Check the Main Controller Wire
B: Replace the PCB Board
E02
Motor communication error
A: Check the wire from motor to controller
B: IGBT breakdown, Replace the controller
C: Check the power voltage if 50% lower than rate
voltage
D: Replace the motor wire or replace motor
E04
Incline Motor communication error
A: Check the wire from incline motor to controller
B: Replace the incline motor
C: Replace the controller
E05
Over current protector
A: Over loading or over resistance, restart the treadmill
B: Transmission parts seized up, check the parts
C: Replace controller
D: Motor breakdown, replace the motor
E06
Motor Open Circuit
Connect the Motor link
E08
IC Driver Error
Replace the IC driver
E09
Folding up protect
A: Do not fold up the running deck when treadmill in is
running
B: If the running deck in laying position and show E09,
you need change the controller
E10
Motor instantaneous current
abnormal
A: Adjust the torsion potentiometer of the Controller to
lower
B: Motor Breakdown, change the motor
E11
Over voltage protector
Voltage over 150v (for 110v) -- turn off the treadmill and
check the power source
E13
No singnal to console from
Controller
A: Check the Main Controller Wire
B: Replace the controller
E14
Lower voltage protector
Voltage lower than 70v (110v) -- turn off the treadmill and
check the power source
