Diamondback 460 Series, Owner'S Manual

Page: 7 / 36

460 Series
f
Owner’s Manual
7
460Ub Assembly Instructions
Frame and Seat Assembly
1. Place the unit and all accompanying parts in a clean, flat, and open space.
2. Attach the Stabilizer Bar to the rear of the frame using two M10 x 20mm bolts.
3. Attach the Transport Bar to the Front of the Frame using two M10 x 20mm bolts.
4. Loosen the seat pin by turning it counter clockwise 1-2 turns. Install seat post
by sliding into the Seat Post receptor, pulling the Seat Pin out until a suitable
hole is found.
WARNING: Never mount the cycle unless the Seat Pin is fully and properly
engaged in the Seat Post.
5. Place the Seat on the rod at the top of the Seat Post. Adjust the seat so that it
is flat and pointing forward and then tighten the nuts on the Seat’s bottom
simultaneously using two wrenches.
Console Mast Assembly
1. Hold the Console Mast with the tube end facing down and slide the Console
Mast Cover onto it as far as possible, with the tabs facing down.
2. Hold the Console Mast next to its mounting post on the front of the Frame.
Feed the wire harness through the Console Mast so that it is attached on the
Frame end and the other end comes out the top of the Mast.
3. Slide the Mast onto the mounting post. Be careful not to pinch the wire
harness while doing this, doing so could cause the unit to malfunction.
Attach the Mast to the mounting post using five M8 x 15 mm bolts and four
M8 curb washers on the front and back of the mast, and an M8 flat washer
on the side. Carefully snap the Console Mast Cover into place on the Frame.
4. Align the Handlebar with its post near the top of the Console Mast so that
only one bolt hole is facing upward. Feed the wires from the Handlebar up
through the top of the Console Mast. Slide the handlebar onto the console
Mast whole pulling gently on the wires to take up the slack. Attach the
Handlebar to the Console Mast using three M8 x 15mm bolts and three M8 f
flat washers.
Console Assembly
1. Connect the plugs from the main wire harness and the hand pulse harness to
the plug receptors on the back side of the console, taking care to install
correctly (See plug alignment marks)
2. Carefully feed the slack in the wires into the Console Mast and place the
Console on the mounting plate
3. Fasten the console to the console mounting plate with four M5 x 15mm
screws using a Phillips screwdriver.
Note: Console may be operated using batteries or the AC Adapter that came
with the unit. If it is going to be operated using batteries the AC Adapter MUST
be unplug from the unit.
Pedal Assembly
1. Use a 15mm open-end wrench to firmly affix the pedals to the cranks.
2. The left and right pedals are different and are denoted as right or left (R or L)
on the top and bottom of each pedal. Please Note: the left pedal threads
counterclockwise.
3. Retighten the cranks after approximately 10 hours of use.
Water Bottle
1. Place the bottle holder on the Console Mast. Insert and tighten the two ST5 x
15mm screws using a Phillips screwdriver.
2. Snap the water bottle into the holder.