37
“
C
ONSOLE
T
ROUBLE
S
HOOTING
G
UIDE
“
PROBLEM POSSIBLE CAUSE SOLUTION
The Speed
Display
Show “O”
The Computer isn’t
receiving a signal
from the Speed
Sensor?
Verify the gap between Speed Sensor and the Magnet is 5mm or less
Verify that all the Wire Plugs are connected FIRMLY, correctly and are not
damaged
Verify that the sensor Magnet is installed correctly
The Sensor is faulty Replace the Speed Sensor
The Computer is
faulty
Replace the Computer
The LCD
Screen
Partially
Displays
1.
The connection
between the
Circuit Board and
the LCD
Membrane is
loose.
2.
Gently press
down on the LCD
Screen, if the
partial display
disappears, then
it is a connection
problem
Verify that the Circuit Board is securely fastened to the Computer Case. Retighten
the Screws. Take care NOT to over tighten the Screws as this may destroy the
Circuit Board. You just need to keep the Circuit Board firm, STOP tightening screw
when you meet resistance
The Rubber
Membranes between
the Circuit Board and
the LCD Screen is
misaligned/not in a
same line. You might
be able to see that
the LCD Screen is on
a slight angle and
NOT inline or parallel
with the Console
Cover
1.
Open the Console.
2.
Remove the Circuit Board
’s Screws, gently remove the Circuit Board,
Re-align the LCD screen and the Rubber Membrane.
3.
Reassemble the Circuit Board and taking care not to bump or knock the
Rubber Membrane out of alignment before the Circuit Board Screws are tight.
You just need to keep the Circuit Board firm, STOP tightening screws when
you meet resistance
The Computer is
faulty
Replace the Computer
Summary of Contents for 1060Ef
Page 42: ...40 PRODUCT PARTS DRAWING A ...
Page 43: ...41 PRODUCT PARTS DRAWING B ...
