Diamond G280A HC, Manual

Page: 10 / 22

E E N N
4 UNPACKING
The appliance must be installed by authorized personnel, in compliance with the current laws in force and the
Manufacturer’s instructions.
Once you have removed the packaging according to the instructions on the box, MAKE SURE THAT THE APPLIANCE IS IN A
PERFECTLY GOOD CONDITION. IF IN DOUBT, DO NOT USE IT AND IMMEDIATELY CONTACT THE DEALER who sold it to
you.
All the packaging items (plastic bags, cardboard, polystyrene foam, nails, etc.) must be removed and put out of the reach
of children, as they are potential sources of danger.
With the pallet resting completely on the ground, lift the appliance with lifting gear suited to its weight and separate it from the
wooden pallet.
NOTE FOR INSTALLER:
This operation must only be performed by professionally qualified and authorized personnel.
The appliances contain threaded holes for hooking eyebolts (Fig. 2). To prevent damage to the appliance, the lifting bolts should
be kept vertical during lifting.
5 INSTALLATION
5.1 CONNECTION DIAGRAM (Fig. 3)
6. electrical connection controlled by omnipolar circuit-breaker with residual current device
7. water tap(s)
8. water supply pipe for ice making
9. water supply pipe for water cooling (W)
10. water drainage pipe
11. cooling water drainage pipe (W)
5.2 POSITIONING
The appliance must be installed in a hygienically clean location; it is advisable to avoid rooms like cellars and store-
rooms, because failure to meet hygiene requirements is likely to lead to the formation and proliferation of bacteria in the
appliance.
The appliance can operate at an ambient temperature of between 10°C and 43°C. The best performance will be obtained
by installing the appliance in a place with an ambient temperature of between 10°C and 35°C and a water temperature of
between 3°C and 25°C.
Avoid direct exposure to sunlight and do not install near heat sources.
This appliance:
• must be installed in a place where it can be supervised by skilled personnel
• must not be used outdoors
• must not be installed in damp places or where it is liable to be sprayed with water
• must not be cleaned with jets of water
• must be allowed a clearance of least 20 cm all around
The connection of the appliance with the accessories must be carried out by professionally skilled and qualified
personnel.
The accessories are supplied with instructions showing the correct connection to the appliance
The liability for damages to persons, animals, objects or to the appliance itself caused by improper installation of the
accessories, is exclusively of those who performed the installation.
The manufacturer declines all liability for installation of accessories supplied by other manufacturers.
The appliance must be installed on a bin.
For correct installation on our bins, see the diagrams supplied with the bins.
In any event the instructions and advice contained in this manual must be complied with, especially those relating to connection to
the electricity and water supply.
Use a spirit level to ensure that the appliance is standing perfectly level. If necessary, adjust the legs fitted to our bins.
The manufacturer declines all liability for installation on bins made by other manufacturers.
5.3 CONNECTION TO THE WATER MAINS