DAT3X
INPUT
WOOFER
MID
TWEETER
DEVX
DEX
MIDRANGE MOUNTING
TWEETER MOUNTING
When flush mounting tweeters, make sure the desired
location can accommodate the hole size and depth
required. Mount the cup using provided hardware. Mount
surface cup at desired angle with provided screws in
tweeter mounting kit. Route speaker wires through
tweeter cup, connect tweeter to wires, and snap tweeter
into cup by aligning the notches.
Mounting Hole size: 1.73” (44mm) Dia.
Determine a location in the door that will accept
the size of your new speake
r
. Remove the door
panel from the door and check for clearance in
the intended speaker location while operating
window all the way up and down.
A
void cutting
any structural metal to mount the speak
ers or
to accommodate additional depth.
I
f depth or a
flat surface mount are an issue
,
please seek the
skills of a professional inst
allation technician.
If you are mounting the speakers in the rear of the
vehicle, there are often two options for achieving
a good mount. Some speakers mount from the top
side (from the interior) while other applications have
the speakers mounted from the bottom side (from
the trunk). In either case, a flat mounting surface and
a good seal are still extremely important.
SYSTEM CONNECTION
DE65C
Each DE crossover has a tweeter attenuation jumper an
d
a phase adjustment located under the
removable cove
r
. Choose “0” or “-2dB”. If the tweeter is significantly closer to the listener than the
midrange, this adjustment should improve the frequency level balance. Choose “0” or “180” by
aligning the jumpers vertically or horizontally
a
s shown inside the crossove
r.
This adjustment may
improve frequency response depending o
n
the tweeter mounting location relative to the midrange.
DE65V
Each DEV
crossover has a tweeter phase switch located under the removable cove
r
. Choose “0”
or “180”.
This adjustment may improve frequency response depending on the tweeter mounting
location relative to the midrange.
DE365C
Each DAT3X crossover has a tweeter phase switch located under the removable cove
r
. Choose “0”
or “180”.
This adjustment may improve frequency response depending on the tweeter mounting
location relative to the midrange.
RAF(REAR ACCOUTIC FILL -AND HOW TO USE IT)
There is a special propietary feature with Diamond Audio
passive crossovers (2 ways only) Its called RAF
(Rear Acoustic Fill) . It makes a car “image and stage”
better than any front/ rear fader on a radio can do.
You can bridge your 4 channel amplifier for triple the power
(and way more dynamic range) to your front midbass drivers,
then connect your rear speaker to our RAF circuit.
This circuit automatically reduces the rear speaker level by -10dB.
DEVX
©2014 Diamond
Audio
. All rights reserved.
(a division of CV & DA Holdings, Inc.)
©2014 Diamond
Audio
. All rights reserved.
(a division of CV & DA Holdings, Inc.)
DE Speaker Manual 2013.indd Spread 4 of 4 - Pages(4, 5)