6
REVERSING THE DOOR
How to reverse the door
Remove the lower hinge by loosening and removing the screws with scredriver.
Carefully lower the door and remove it.
Remove the two screws from the left top hinge position, take the metal part off the hinge
position.
Remove the two screws from the right top hinge and take off the hinge, insert the metal part,
rivet the two screws thereafter.
Take off the lower hinge and fix it to the opposite side.
Take the door. Insert the lower hinge axle into the right bottom hole of the door.
Fix the spare hinge to the left top position of the cabinet. Adjust the door, make it straight and
in alignment with the cabinet.
Note: As the door gasket gets pressed-in during shipment, after reversing the door the gasket might
have to be reset. This will be good for seal to avoid any air escaping. If there is a gap between the
cabinet and the door gasket, set the gasket by gently pulling it out to seal the gap. If necessary, you
are recommended also to use the hair drier to warm the gasket to get rid of the gap.
PROPER ABSORPTION MINIBAR CARE AND CLEANING
Warning:To avoid electric shock always unplug you absorption refrigerator before cleaning.
Ignoring this warning may result in injury.
General:Do not use harsh chemicals, abrasives, ammonia, chlorine bleach,
concentrated detergents, solvents or metal scouring pads. SOME of
these chemicals may dissolve, damage and/or discolor your absorption refrigerator.
1) Remove the contents of the appliance
2) Wipe the inside and outside surfaces with a damp cloth. The addition of vinegar to the
water is good for the prevention of mold and fungus.
3) Wipe all parts thoroughly after the cleaning.
IMPORTANT:
When the absorption refrigerator is not in use it must be completely dry inside to avoid mold
growth (if possible have the door open).
