St
8 Fitti
th G ill
Step 8 Fitting the Grill
Screw the Grill to the front of the Plinth Heater using the 2 shorter screws at point “A” Secure
the grill to the plinth using the longest screws at point “B”
A
B
B
Operation
Switch the unit on at the socket. Set the heating switch to the red disc position. Select the
fan speed to Low or Boost. The fan will start to rotate provided hot water is circulating
through the heat exchanger at or above 43degrees C. If the central heating system has just
been switched on there may be a delay in the fan starting till the system reaches 43degrees
C.
When the central heating system switches off and the system temperature drops below
43degrees C the fan will stop automatically.
During the summer the plinth heater can be used for air circulation without heat.
Set the heating switch to the Blue disc position. In this position the fan will run until the
unit is manually reset.
“0” Winter switch
“1” Summer switch
“I” Low
4
“0” Off
“II” Boost
