Diamond Systems OSBOURNE, User Manual

Page: 17 / 38

Osbourne User Manual V0.21 www.diamondsystems.com Page 17
6 CONNECTOR AND JUMPER LOCATION
6.1 Jumper Selection
The Jumper blocks on the Elton baseboard can be configured to enable/disable or alter the default signal routing
settings on the circuit, using Jumper shunts.
The following table describes the Jumper Blocks on the baseboard.
Jumper Description
JP1
Serial Termination Enable/Disable
JP2
DIO voltage selection/DIO push pull selection
JP3
PCIe/Minicard selection, Configuration, WOL,
Auto Power Selection
6.1.1 Serial Port Termination Jumper Selection
JP1 Jumpers Configuration are provided enable and disable the termination of serial ports1-2.
Position Function IN OUT
TX1 121E Termination Enabled for SER1 TX RS-485/RS-422 Mode Enabled Disabled*
RX1 121E Termination Enabled for SER1 RX RS-485/RS-422 Mode Enabled Disabled*
TX2 121E Termination Enabled for SER2 TX RS-485/RS-422 Mode Enabled Disabled*
RX2 121E Termination Enabled for SER2 RX RS-485/RS-422 Mode Enabled Disabled*
*Default Mode
6.1.2 DIO Jumper Selection
JP2 Jumpers are provided to select the voltage level and Pullup/pull down configuration of the DIO. By default,
the DIOs are 3.3 Volare pulled down. The configuration is as shown below:
Position Function IN OUT
5V DIO Voltage Level 5V
3V3 DIO Voltage Level 3.3V*
PU DIO Pull up Enable Enabled Disabled
PD DIO Pull down Enable Enabled* Disabled
*Default Mode
Note: Make sure 5V and 3V3 Jumper are not IN at same time.
6.1.3 Configuration Jumper Selection
JP3 Jumpers Configuration are provided to select the Voltage level of Digital I/Os. By default, the DIOs are 3.3 V.
The configuration is as shown below:
Position Function IN OUT
PCIE x16 PCIE / MINICARD Selection x16 PCIE MINICARD*
CFG Boot Configuration Config #2 Config #1 *
WOL Wake on LAN Enabled Disabled*
AUTO Auto Power Enabled Disabled*
*Default Mode