Charge your Sensor
Remove the sensor from the sensor mount.
Plug the charging station into a powered
USB port. Place the SwingTracker in the
center of the charging station. The sensor
light will change from a blinking red to a
solid green light when fully charged.
Never force a charge cable into the USB port of your SwingTracker
charging station. If the charge contact does not easily fit, confirm
that they are properly aligned before attempting to insert again.
ONLY use the USB charging cable provided to charge your
SwingTracker sensor. Diamond Kinetics is not responsible for the
operation of thirdparty accessories.
Check Battery Life and Power
Turning The Sensor On
: With the sensor attached, tap the bottom of bat on the
ground twice to turn on the sensor. You will see a green light flash rapidly if not
paired. The light will flash slowly when paired to an iOS device.
Determine Battery Charge
: A battery indicator is listed at the top of the
SwingTracker app screen when you are paired with the app collecting swing data.
The sensor will blink red and app will alert you when the battery is low.
Sleep Mode
: The sensor will go into sleep mode and the light will stop blinking if
you stop using it for five minutes. It will automatically wake up and the green
power light will turn on once the sensor is picked up.
Turning The Sensor Off:
The sensor will turn off automatically if the sensor does
not move for 15 minutes.
The battery will last up to 7 hours with continuous use.
SWINGTRACKER APP
Download the Mobile App
