MODEL BMGP-600 GRINDER
SECTION 7
MAINTENANCE
50
Grinding & Polishing
OPERATING MANUAL
DECEMBER 2008
Plug Removal:
1.
Make sure that the power supply is disconnected from the electrical power source per
the Safety Off position described in Section 2.6.
2.
Place the handle in the “Up” position.
3.
Swing the weights to the rear position and secure in place.
4.
Tilt the machine back so that the handle rests on the ground and tooling is exposed.
5.
Make sure the machine is secure and cannot fall back on the head.
6.
Using a hammer, hit the bottom of the tooling plates to dislodge the tools from the plate.
7.
The tools should fall out.
Plug
Installation:
8.
Clean out the tooling holes to remove remaining dust.
9.
If replacing the tooling with used plugs, notice the (add photo) tail and install so that the tail
follows the direction.
10.
Insert into the holes and slightly twist until it tightens.
7.4 TOOLING CHANGEOVER
Diamond Plugs
Plug Style Polishing Dots
