Document No: 9100-127-1958-99 Rev F
1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732)
919-3119 Fax: (732) 751-5778 www.dialight.com
H)
Select the status of side lights. Use “UP” and “DWN” buttons to change from
STEADY, DISABLED and FLASHING, depending on what is needed of the
sidelights.
NOTE:
This is a global change that will affect all tiers of sidelights; individual
tiers are not able to have statuses changed.
L810 stat = STEADY
u/d=chg, enter=done
L810 stat = Disabled
u/d=chg, enter=done
L810 stat = Flashing
u/d=chg,
enter=done
I) Select red mode flash rate of the beacons as well as the sidelights when
specified to be flashing as indicated in step H. Selections available are 20, 30,
and 40. Use “UP” and “DWN” buttons to change, and them press “ENTR”
NOTE:
Factory default is 30fpm
NOTE:
This is a global change that will affect all tiers of sidelights at once.
NOTE:
This change will not affect white flashes.
Flash per min = 30
u/d=chg, enter=done
J) If sidelights are to be calibrated at this time (if not calibrated as per the previous
section of this manual or the quantity or wiring of sidelights has changed since
previous calibration), use “UP” and “DWN” buttons to change from “NO” to
“YES”, and then press “ENTR.” The system will reset and the sidelight board
will perform its calibration sequence.
NOTE:
This step should only be selected if all tiers of sidelights are fully installed
and connected to the controller.
RECAL L810 = NO
u/d=chg, enter=done