DIAGAUTO MST-500, Instruction Manual

Page: 5 / 17

深圳宙斯特科技有限公司
- 5 -
Attentions
Use restrictions
1. The displays screen and illustrations (such as key markings) in this manual are for
illustrative purpose only, and may differ somewhat from the actual items they
represent.
2. The contents of this manual are subject to change without notice.
3. In no event shall
Shenzhen Zeus Technology Co., LTD
be liable to anyone for special,
collateral, incidental, or consequential damages in connection with or arising out
of the purchase or use of these materials.
4. Shall
Shenzhen Zeus Technology Co., LTD
not be liable for any claim of any kind
whatsoever against the use of these materials by any other party.
5. Avoid use and storage in areas subjected to temperature extremes. Very low
temperatures can cause slow display response, total failure of the display. Also
avoid leaving the scanner in direct sunlight, near anywhere else it might be
exposed to very high temperatures. Heat can cause discoloration or deformation of
the scanner's case, and damage to internal circuitry.
6. Never attempt to
disassemble
the scanner or tamper with the connection settings
without permission.
7. Never press the keys of the scanner with a ballpoint pen or other pointed object.
8. Use a soft, dry cloth to clean the exterior of the scanner. If the scanner becomes
very dirty, wipe it off with a cloth moistened in a weak solution of water and a
mild neutral household detergent. Wring out all excess moisture before wiping the
scanner. Never use thinner, benzene or other volatile agents to clean the scanner.
Doing so can remove printed markings and can damage the case.
9. Working conditions:
Temperature
：
0
～
60
℃
；
Humidity: relative humidity below 80%.
10. Don't connect to diagnostic test sync when examine the ignition system sparking
voltage Test, or high-pressure disturbance may result in equipment damage
Checking when use
1
．
Check whether the ignition is on.
2
．
Check the whether the scanner's power light is on (red light), when testing the
system whether the signal light is flash.
3
．
check the diagnostic cable and the interface whether is bad contact or
short-circuit.
4
．
Check whether the software version is applicable to the vehicle types