Di4 80104635, Manual

Page: 25 / 72

25
steam function while the hand touches the handle from the upper part. If the iron is not touched the
variable steam function will be stopped.
After the initial heating, “Sense Technology” function switches off the iron when it is left unattended,
thus increasing security and saving energy.
1. While the handle is gripped, the iron heats up.
2. When the handle is released, the iron stops heating up. The indicator lamp will flash.
INJECTION STEAM
The appliance has an injection steam system that injects water to the soleplate in order to facilitate a
greater penetration of steam into the garments. You will notice this function as a small vibration when
product is working under steam ironing function.
Troubleshooting
Problem Posible causa Solución
The iron does not heat up. The “Sense Technology” function
has been activated. The iron is
set to stand-by. Grip the handle of the iron to
re-start it.
The clothes tend to stick. The temperature of the soleplate
is too high. Select a lower temperature and
wait until the iron has cooled
down.
Water drips out of the soleplate
when using the shot of steam
function. You have pressed the shot of
steam button repeatedly without
waiting for 5 seconds between
each press. Wait 5 seconds between each
press of the shot of steam
button.
Excessive dripping or steaming. No proper closing of “clean”
button. Point the iron away from the
ironing area. Actuate a few times
the “clean” button.
The motor does not work. 1. The iron is not in a horizontal
position.
2. The soleplate is heating up.
1. Use the iron in a horizontal
position.
2. Wait until the selected
temperature is reached.
Smoke comes out when
connecting the iron for the first
time. This may be caused by the
lubrication of some of the
internal parts. This is normal and will stop after
a few minutes.