5
2.Panel Description
Ω
Ω
2A
20A
200A
1000A
200
OFF
MODE
MAX
PEAK
HOLE
MIN
COM
V
CAT III
600V
V
mA
TRUE RMS AC CLAMP
LEAKAGE CURRENT TESTER
AUTO
POWER
OFF
1
2
6
3
4
5
8
7
9
10
MAX
PEAK
Ω
°C°F
MIN
H INRUSH WIDE
50 60Hz
AC
DC
AT
Hz
mA
V
k
P
1.Transformer Jaw
2.Transformer Trigger
3.Function Selector Switch
4. Max/Min Hold Button
5. Peak hold Button
6 .Data Hold &Backlit Button
This is used to pick up current signal.
To measure AC current, conductor must
be enclosed by the 68 mm diameter jaw.
This is used to open the jaw.
This is used to select the function user
desired, such as AC/DCV ,ACA, ohm and
continuity.
This button is used to enable the
maximum or minimum value to be
displayed and updated during measurement.
Press once, minimum value shall be
displayed and updated. press again,
maximum value shall be displayed and
updated. Press & hold the button again
(the third push ),clamp meter return to
normal measurement mode.
This button is used to enable the Peak value to be displayed and updated during
measurement. Press again clamp meter return to normal measurement mode.
once this button is pushed,reading shall be held on the LCD. Press again to
release it. Press & hold the button 2 Sec. release backlight is on, again press &
hold the button 2 Sec. release backlight is off.
True RMS AC Clamp Leakage Current Tester User’s Manual
