13
Version 3.1 May 2018
Den Haan Rotterdam
MOUNTING INSTRUCTIONS
Mounting plate
The mounting plate for navigation lights should be at least 5 mm thick and should not exceed a parallelism
of // 00,5.
Fasteners
• The permissible torque should be 8 Nm
• Use only A4-grade stainless steel
Cable glands
Important
Do not paint or use any other chemical for the lanterns, clean only with fresh water.
Bolt M10 x (40 + M)
Lantern base
Washer M10
Mounting plate Min. 5 mm
Nut M10
M
All dimensions in mm
ØD
Preferred cable diameter D is 6 - 9 mm
Cable too tight!
This gives unwanted stress at the sealing of the
cable gland and water ingress will occur.
Include cable slack at the entering
point of the cable gland
Replacing cable gland
• Use gasket between housing
and cable gland
• Tighten firmly (6Nm) with
wrench
Washer M10
Remove the plug before placing the cable.
If no cable is connected leave the plug in place!
