DHR DHR420RCB, Technical Manual

Page: 6 / 22

6
Version 1.3 Nov. 2017
Den Haan Rotterdam
1. MOUNTING INSTRUCTIONS
Mounting the panel
Place the control panel inside the wheelhouse, where it is protected against weather influences. The housing
is especially constructed to be flush mounted in an instrument cabinet according the illustration below.
The minimum space needed behind the panel is 60 mm. (depth)
Searchlight installation
Install the searchlight in a horizontal upright position with sufficient space around the head of the search-
light to ensure it can move freely. The dimensions can be found on page 9.
Warning!
Den Haan Rotterdam accepts no responsibility for any damage if the searchlight is installed
incorrectly and/or used improperly. When in doubt consult a qualified electrical technician.
90
90
92
92
75
75
!
Bolt M10x (60 + M)
Insulation sleeve
Lantern base
Insulation sleeve
Washer M10
Mounting plate Min. 5 mm
Nut M10
M
All dimensions in mm
Fasteners
• The permissible torque should be 8 Nm
• Use only A4-grade stainless steel
Caution!
Even though the housing is made of corrosion resistant materials, galvanic corrosion may still occur. To
prevent galvanic corrosion use the supplied insulation sleeves to isolate the aluminium housing from
other metal parts.
4 x Ø10
162,5
162,5