Dhollandia DH-RM.25, Installation Manual, Page: 50 / 79

49
DHOLLANDIA
See overview on
next page
16 MOUNTING OF THE OPTIONAL WALK-RAMP KIT OAM054

The optional walk-ramp kit ref. OAM054 is designed to be bolted to the extension plate. It consists of:
1. Walk-ramp carrier assembly [1 in Figure 16.1]
2. 2 pcs. 114mm deep spacer tubes for the dock bumpers [2 in Figure 16.1]
Figure 16.1

The walk ramp carrier assembly consists of:
1. Mounting brackets [A in Figure 16.2], that can be mounted in 2 positions with 25.4mm height difference.
2. Platforms stoppers [B in Figure 16.2], that can be adjusted in height steps of 25.4mm and rotated.

Test mount the walk-ramp carrier assembly to the extension plate at the height that gives the adequate clearance for the walk-
ramp to slide in and out.

LIFT the folded platform into the intended travel position. Adjust the height and orientation of the platform stoppers [B on Figure
16.2], so that they touch and stop the main steel reinforcements on the underside of the platform main section.

Fasten all bolts and nuts to the prescribed torque. Pressurize the platform against the stoppers [B] to ensure all bolts are properly
secured.

LOWER and LIFT the folded platform at least 3 times. Verify and ensure the platform can unfold and fold freely, without any
interference with the walk-ramp assembly; extension plate, or the vehicle chassis.
Figure 16.2